Sbs penetration detail

Slit fabric to fit over roof penetrations, cut out around roof drains and other openings. When cast-iron roof drains are used; a sump receiver and under-deck clamp must be provided and installed by the trade supplying the roof drain. NovaLink 35 is designed for use with many building materials including concrete, glass, metal and most roofing materials. System Building Services provide diamond core drilling services allowing us to ensure a fully managed service. The security code review enables a scrutiny of your application standard code and other code sets for accidental security vulnerabilities and deliberate application backdoors.

They are simple to work with and fix and can easily be cut, drilled Response Procedures Equifax has set up a website https: Proprietary root intrusion barriers must be acceptable to the roof membrane manufacturer and appropriate for the vegetation system installed. Counter Flashing with Kick Out Detail. Specialized proprietary drainage products must be acceptable to the membrane manufacturer.

DuraLink 35 is a multi-purpose, moisture cure, elastomeric sealant that combines economy and high performance. Flanges - All roof flanges in contact with asphaltic membranes of any type shall be primed both sides with membrane manufacturers approved primer and embedded in a trowel coating of compatible mastic. Built-in membrane gutters that drain a roof not covered by a RoofStar Guarantee are not eligible for a Guarantee. Protection for roofing membranes is required during the installation and maintenance of landscaping, extensive and intensive vegetated green roofing installations. FlashPack Liquid Flashing is designed to waterproof around odd shaped roof penetrations in difficult flashing conditions. Reinforcement fabric shall be embedded into a liberally applied, thick resin base coat approximately 3mm with no wrinkles, buckles, or ridges.

System Building Services provide, advise on and install high-performance, non-combustible fire protection boards for the encasement of columns and beams. Cap sheet stripping is required and must extend mm 6" horizontally and mm 8" vertically from the base of all upstands. Only polyisocyanurate insulation with non-organic facers e. Attachment of base sheets shall be a minimum of one nail, with a minimum 25mm 1" nominal head size, per 0. Curbed openings HVAC, skylights, etc. Acceptable wood roof decks may include wood board decks, plywood decks, and, subject to restrictions, non-veneered wood decks oriented strand board, waferboard, etc. Concrete decks, curbs and equipment pads must be clean, dry, and smooth prior to commencement of roofing.